Skip to content
New raiser on an Ingleburn home
Level 2 electrical

Point of Attachment Upgrade Campbelltown

Getting the line clear of carports, caravans, granny flat driveways and new roofs.

Get a free quote

Takes a minute. We'll call you back, usually the same day.

No obligation. Your details stay with us and are never sold or shared.

The point of attachment is where Endeavour Energy’s overhead service line meets your house. On single-storey Campbelltown estate homes it’s usually a galvanised raiser above a tiled roof; on two-storey homes, a bracket on the upper wall. It carries the line’s tension and decides how high the line sits over your driveway, carport and roof.

Why it needs changing

Carports and caravans. Wide estate driveways hold carports, caravans, boats and work utes. A line that cleared a sedan in 1980 may not clear a caravan today. The Service and Installation Rules of NSW set minimum heights over driveways.

Granny flats. A flat down the side or out the back can put new structures and a driveway under the line.

Second storeys. The new floor can bury the bracket or put windows near the line.

Re-roofs. Tiles out, metal on: the raiser comes out and goes back, and often needs replacing.

Storms and sun. Decades of heat and wind wear out raisers and loosen brackets.

Storm folded the raiser or dropped the line? Stay well back and ring our emergency level 2 electrician team.

Raisers and brackets

On single-storey homes, a raiser fixed to the roof framing lifts the attachment above the roofline. On two-storey homes, a bracket fixed into sound brickwork or structure does the job. We choose a position that gives the line a clean, compliant run from the pole, clear of the driveway and anything parked on it.

Do it with the mains

Moving the attachment usually means extending or replacing the mains. If they’re original, a consumer mains upgrade on the same day saves a second outage. For renovations, we handle the power disconnection and reconnection and reconnect to the new fitting at the end.

Defect notices

Endeavour Energy can issue a defect notice if a line is below the required clearance or a fitting is damaged. We fix it within the timeframe and give you the certificate.

Clearances in plain terms

The line must stay above minimum heights over footpaths, driveways and roofs, and a minimum distance from windows, balconies and decks. Getting it right matters more on blocks with tall vehicles parked out the front.

How long it takes

Expect us for a morning or an afternoon; the house is only without power for a couple of hours of that.

On the day

We notify Endeavour Energy, disconnect, fit the new raiser or bracket, extend the mains and transfer the line, then reconnect, test and certify.

Re-roofing and the raiser

Concrete tiles coming off for a metal roof is the best time to replace an old raiser, because the roofer has to work around it anyway. We disconnect, the roofer strips and sheets around the opening, and we fit a new galvanised raiser and flashing before reconnecting. Doing it in one go saves a second outage and stops the leak that often starts at an old raiser penetration.

Second storeys

When a single-storey Campbelltown home goes up a level, the old attachment point is usually in the way of the new walls. We move it to the new structure at a compliant height and run new mains to suit.

Caravans, boats and trucks

Plenty of Campbelltown driveways hold a caravan, boat or work truck that sits higher than a car. If a line crosses where it parks, the clearance needs to suit the tallest thing that passes under it. We measure and set the new attachment height accordingly.

Get a price

Call your level 2 electrician Campbelltown team for a site visit. We raise a lot of lines over carports and caravans in level 2 electrician Ingleburn and Minto.

Updated

The price depends on the raiser or bracket, its height and fixing, what it mounts on and whether the mains need extending. We look on site and give you a fixed price.

What good point of attachment upgrade looks like

Close-up of point of attachment upgrade on a home in the Campbelltown area
What point of attachment upgrade looks like up close on a typical Campbelltown area home.
Signs that point of attachment upgrade needs attention
Typical signs that it needs attention.

Point of Attachment Upgrade in Campbelltown: step by step

  1. MeasureWe check the line's height over the driveway, carport and roof, and the fitting's condition.
  2. Choose a positionA compliant spot with a clean run from the pole that suits your plans.
  3. Fit and move the lineNew raiser or bracket installed, mains extended, line transferred.
  4. ReconnectReconnected to the Endeavour Energy network, tested and certified.

Point of Attachment Upgrade questions in Campbelltown

Something else on your mind? Call 02 9158 9997 and ask.

Our new carport will sit under the line. What do we do?

Have the line raised or moved before the carport goes up, so it keeps the required clearance.

Our raiser is rusted at the base. Is that urgent?

It should be checked soon. Rust weakens the raiser, which carries the line's full tension.

Can a raiser be straightened after a storm?

No. A bent raiser should be replaced. Keep clear and call us.

Need a Level 2 electrician in Campbelltown?

📞 Call now Free quote